Table of Contents
Advertisement
Available languages
Available languages
Minimum gage for cord sets
Volts
Total length of cord in feet
120V~
0-25
26-50
220V~
0-50
51-100
Ampere rating
More
No more
American wire gage
than
than
0 - 6
18
16
6 - 10
18
16
10 - 12
16
16
12 - 16
14
12
Features
1. On/off switch
2. Variable speed switch
3. Lock-on button
4. Side handle
5. Spindle lock
Motor
Warning! Be sure your power supply agrees
with nameplate marking.
Instalation
Assembly and adjustment
•
Place the polisher disk on the spindle, mount the
concave recess side of the locking nut over the spindle,
and tighten with the two –hole spanner.
•
Mount the outside spindle over the spindle, Install the
woolen fabrics cover by simply stretching the elastic and
slipping the woolen fabrics cover over the outside
spindle. And let it operate for more than three minutes for
checking it up without load.
Caution! Turn off and unplug from power
supply.
Before operating
Note: Although this discussion deals with polishing a car,
your polisher is capable of polishing a wide array of flat
surfaces such as hardwood floors, furniture, boats and other
51-100
101-150
surfaces that could use an occasional shine. Before you
101-200
201-300
begin, make sure the car is clean and dry. The work area
should be dry also. If necessary, remove road tar with a
general cleaner before polishing. Also remove excess grease
spots, bug stains, etc.
Selecting the correct operating speed
16
14
The work speed of the rotating part is controlled by the
14
12
timing. Switch indicated in figures. The further the switch is
14
12
moved away from its off position, such as from 1 to 2, the
Not recommended
faster the work part rotates.
Operation
•
•
ALWAYS START AND STOP THE POLISHER ON OR
AGAINST THE SURFACE. Place the cord over your
shoulder and do flat surfaces first - hood, trunk and roof.
Cover areas quickly with broad, sweeping strokes in a
criss-cross pattern. DO NOT press down on the polisher.
The machine's action, not pressure, does the best job.
•
•
•
Warning! Before working , let it operate for no less one
minute without load. First , ensure that the polisher disc is
resting on the work surface. Grasp polisher and turn it on.
Move it in long, sweeping strokes along the surface, letting it
do the work.
Handy hints
•
Make sure the polisher is in the "OFF" position before
plugging the polisher into an appropriate power outlet.
To switch your polisher on, press the on/off switch. To
switch it off press the on/off switch.
After flat surfaces are covered with wax, do sides of the
car. Let the cord hang free. It is not necessary to use a
criss-cross motion on doors and fenders.
Put a clean polishing bonnet on the polisher
Polish the wax. Use long, sweeping strokes in a
criss-cross pattern. Do not press hard. Let the polisher do
the work.
This polisher is a random orbit polisher. it is designed to
wobble. The wobbling motion produces the fine, swirl free
finish.
ENGLISH
7
Advertisement
Table of Contents
