Operation Warning - Black & Decker BDEG400 Instruction Manual

raised center on the outer flange must
face towards the disc (A in fig. c). The
raised center on the outer flange must
face toward the disc (B in fig. c).
• Keep the spindle lock (3) depressed and
tighten the outer flange using the two-
pin wrench (15) (fig. d).
C
D
ReMovING
• Keep the spindle lock (3) depressed and
loosen the outer flange (14) using the
two-pin wrench (15) (fig. D).
• Remove the outer flange (14) and the
disc (11).
fITTING ANd ReMovING SANdING
dIScS ANd BAckING PAd (fIG. d & e)
For sanding, a backing pad is required.
The backing pad is available from your
BlAcK+DEcKER dealer as an accessory.
NoTe: Guard may be removed when
using sanding backing pads.
WARNING
: Proper guard must be
reinstalled for grinding wheel, sanding flap
disc, wire brush or wire wheel applications
after sanding applications are complete.
fITTING
• Place the inner flange (11) onto the
spindle (6) as shown (fig. e). Make sure
that the flange is correctly located on the
flat sides of the spindle.
• Place the backing pad (16) onto the spindle.
• Place the sanding disc (17) onto the
backing pad.
• Place the clamp nut that came with the
backing pad (14) onto the spindle with the
raised center facing away from the disc.
• Keep the spindle lock (3) depressed
and tighten the clamp nut using the two-
pin wrench (15) (fig. d). Make sure the
clamp nut is fitted correctly and the disc
is clamped tightly.
E
ReMovING
• Keep the spindle lock (3) depressed and
loosen the outer flange (14) using the
two-pin wrench (15) (fig. d).
• Remove the clamp nut (14), the sanding
disc (17) and the backing pad (16).
MouNTING ANd uSING WIRe
BRuSheS ANd WIRe WheelS
Wire cup brushes or wire wheels screw
directly on the grinder spindle without the
use of flanges. Use only wire brushes or
wheels provided with a 5/8 inch-11 threaded
hub. A Type 27 guard is required when
using wire brushes and wheels. Wear
work gloves when handling wire brushes
and wheels. They can become sharp.
Wheel or brush must not touch
guard when mounted or while in use.
Undetectable damage could occur to the
accessory, causing wires to fragment from
accessory wheel or cup.
MouNTING WIRe cuP BRuSheS ANd
WIRe WheelS
Turn off tool and unplug tool before
making any adjustments or removing or
installing attachments or accessories.
1. Thread the accessory on the spindle
by hand.
2. Depress spindle lock button and use a
wrench on the hub of the accessory to
tighten the accessory.
3. To remove the accessory, reverse the
above procedure.
cAuTIoN:
the accessory hub before turning the tool on
may result in damage to tool or accessory.
oPeRATIoN
WARNING:
used in temperatures below -4°F (-20°c)
or above 104°F (40°c).
Switching on and off
cAuTIoN:
and trigger handle firmly to maintain control
of the tool at start up and during use and
until the wheel or accessory stops rotating.
Make sure the wheel has come to a
complete stop be fore laying the tool down.
8
Failure to properly seat
This tool should not be
Hold the auxiliary handle