Siemens SIMATIC IM151-1 Manual page 15

2.2.5 Option handling: Slot 2 to 63
This parameter can be used to enable or disable checking the configuration.
● Slots 2 to 63 are enabled: Instead of the configured electronic module you can also insert
● Slots 2 to 63 are disabled: Only the configured module can be located on the relevant
2.2.6 Diagnostic interrupt
This parameter can be used to enable or disable diagnostic interrupts. Diagnostic interrupts
are supported
● on PROFIBUS DP, if the ET 200S is in DPV1 mode.
● and on PROFINET IO.
2.2.7 Process interrupt
This parameter can be used to enable or disable process interrupts. Process interrupts are
supported:
● On PROFIBUS DP, if the ET 200S is in DPV1 mode.
● On PROFINET IO.
2.2.8 Insert/remove-module interrupt
This parameter can be used to enable or disable remove/insert module interrupts.
Remove/insert module interrupts are supported
● On PROFIBUS DP, if the ET 200S is in DPV1 mode
● On PROFINET IO.
2.2.9 Analog-value format
You set the number format for all analog electronic modules here.
IM151-1 HIGH FEATURE interface module (6ES7151-1BA02-0AB0)
Manual, 03/2008, A5E01075975-02
a RESERVE module in the relevant slot without diagnostics being reported.
slot. RESERVE modules are treated as incorrect modules. Depending on the setting of
the parameter "Operation at Preset <> Actual Configuration" the ET 200S will either
terminate or continue exchanging data.
Parameters
2.2 Parameter description
15