3.9.2. Debug UART Port
Through debug tools, the debug UART port can be used to output logs for firmware debugging. Its baud
rate is 115200bps by default. The following is a reference design of debug UART port.
3.9.3. Auxiliary UART Port
The auxiliary UART port is designed as a general purpose UART for communication with DTE. It also
supports log output for firmware debugging, and hardware flow control*. Its baud rate is 115200bps by
default. The following is a reference design of auxiliary UART port.
BC66_Hardware_Design
Module (DCE)
Main port
TXD
RXD
GND
Figure 15: Reference Design for Main UART Port
Module
TXD_DBG
RXD_DBG
GND
Figure 16: Reference Design of Debug UART Port
NB-IoT Module Series
BC66 Hardware Design
DTE
Serial port
TXD
RXD
GND
DTE
TXD
RXD
GND
29 / 59