Cleaning; Maintenance; Substituting Power Cables; Reset - Fiamma FF 6 NV Operating Manual

ENGLISH
5. Use a metallic brush to take out all residues and leftovers from the walls and the bottom of the vat
6. After having cleaned the vat from leftovers, wipe the vat with a soft cloth
7. Close the tap and fill the vat with fresh oil or fat.
8. Remount the headpiece onto the body of the deep fryer and fasten the fixing elements.

5. Cleaning

Always disconnect the equipment from the power supply before proceeding to any cleaning
intervention.
Never immerse the headpiece in water
Always let the deep fryer and the fat or oil in the container cool down completely before cleaning.
Do not use jets of water to clean the equipment. Do not pour water onto the equipment or onto
any of its attached components.
Do not use solvent, abrasive or acid detergents on the equipment!
 Clean the fryer daily.
1. Disconnect the equipment from the power supply.
2. Make sure the fat or oil are cold.
3. Take off the deep fryer's head piece and take out the fat, following the instructions for filtering.
Never immerse the headpiece in water. Instead, clean it with a soft cloth and liquid detergent.
4. Clean the equipment's exterior with a soft humid cloth and some mild detergent.
5. Wash the basket, the protection grid for the heating elements and the container in water.
6. Maintenance 
Only suitably qualified and competent persons may install and repair the deep fryer. Repairs and
other work by unqualified persons are dangerous and the manufacturer will not be held liable for
any resulting damage.
Installation and repair works must strictly comply with current local and national safety regulations.
Substituting power cables 
6.1.
In case it's necessary, substitute the power cable with the following cable types, supplied by the
manufacturer or official agents:
Monophasic models: cable type H07RN-F 3G1.5 mm
Triphasic models with 5.1 kW: cable type H07RN-F 5G1.5 mm
Triphasic models with 7.5 kW: cable type H07RN-F 5G2.5 mm
The triphasic models require a 5-point-plug.
Reset 
6.2.
The fryers are supplied with a safety thermostat with manual reset that shuts down the equipment in
the case of anormal functioning in the temperature control system.
In order to reset, press the reset switch in the interior of the headpiece.
15
Deep Fryers - Operating Manual - 02/03/2015
2
;
2
;
2
.