Download Print this page

Advertisement

Quick Links

ELECTRIC BASS AMP
Owner's Manual
Basspower 600

Advertisement

loading
Need help?

Need help?

Do you have a question about the Basspower 600 and is the answer not in the manual?

Questions and answers

Summary of Contents for FAME Basspower 600

  • Page 1 ELECTRIC BASS AMP Owner‘s Manual Basspower 600...
  • Page 2 Congratulations! We would like to thank you for purchasing the Basspower 600 Electric Bass Amplifi er. It has been specially designed and developed for the use with electric basses. Before using your new amplifi er, we advise to read the following pages carefully.
  • Page 3: Table Of Contents

    Content Setting up the Basspower 600 ..................Peripheral Connections ....................Preamp Section ....................... Parametric Equalizer ......................Controls & Switches I ..................... Controls & Switches II ....................Special Gimmicks ......................Specifi cations ........................10...
  • Page 4: Setting Up The Basspower 600

    Setting up the Basspower 600 WARNING! To avoid electrical shock or any other damage, make sure that the Basspower 600 and all other devices are switched off before you start connecting them to the amplifi er! Power Connections/Mains Main Fuse...
  • Page 5: Peripheral Connections

    Line Out Mains Your Basspower 600 needs to be connected to a PA- This jack is used to connect the Basspower 600 to a System? You would like to record the sound directly grounded power outlet. into your recording desk or audio interface? The Line Out will do just that.
  • Page 6: Preamp Section

    Preamp Section of the Basspower 600 Basics The device features both a solid state and a tube-driven preamp. You can switch between these two preamp modes by using the “Preamp Mode” switch on the left side of the frontpanel. You will notice a con- siderable difference between these two modes.
  • Page 7: Controls & Switches I

    These two knobs are the main equalization of the Basspower 600. Treble controls the amount of high Mutes the power amp of the Basspower 600. Only frequencies, while Bass is responsible for the low fre- the “Tuner Send” jack will receive a signal for your quencies.
  • Page 8: Controls & Switches Ii

    Controls and Switches II We suggest you start exploring the channels with all controls set to 12:00 o‘clock and the master volume slightly cracked open. CONTROLS ON THE BACK Effects Loop -10 dB This feature allows you to set the basic level of the connected effects device.
  • Page 9: Special Gimmicks

    We are convinced that the basic sound of the Fame High-quality effects like a vibrato or time-based units like Basspower 600 will suit the demands of most bass players. delays can round up the sound, when placed in the fx loop Although, the usage of external effects devices can of the amplifi...
  • Page 10: Specifi Cations

    Specifi cations 600 Watts @ 4 ohms Power Output: Tubes: 2 x 12AX7 preamp tubes Passive/Active, Preamp Mode, Par EQ, Mute, Effect, -10dB, Pre/Post, Switches: Ground Lift; Power Switch Equalization: Bass, Treble, 3-band parametric equalizer Effects: Connection Jacks: Input Headphone Out FX Send &...
  • Page 11 BASSPOWER 600 2007...

This manual is also suitable for:

Basspower 600l