Commissioning; Your System Is Preset At The Factory; Special Considerations For Multi Boiler Systems; Terminology - Viessmann Vitotronic 100 Operating Instructions Manual

Vitotronic 100, GC1B Operating

Commissioning

The commissioning and matching of the control unit
to local conditions and building characteristics, as well
as instructing the user in the operation of the system,
must be carried out by your heating contractor.

Your System is Preset at the Factory

The control unit is preset to "
central heating and DHW heating.
Your heating system is therefore ready for operation:
Central Heating
The rooms are heated in accordance with the settings
on your control unit and room temperature control unit.
Your heating contractor can make further settings for you
during commissioning.
You can change any settings individually at any time to
suit your requirements (see chapter "Central heating").

Special Considerations for Multi Boiler Systems

The Vitotronic 100 can be used in the following systems:
Single boiler systems
Multi boiler systems with a Viessmann cascade control
unit
Multi boiler systems of a higher third party control unit
In multi boiler systems (systems with several boilers),
each boiler is equipped with its own control unit. These
control units are regulated by the higher control unit.
Make the required settings (e.g. set room temperature)
at the higher control unit.

Terminology

w " at the factory for
As the user of new combustion equipment, you may be
obliged to notify your local safety regulatory inspector
of the installation [check local regulations]. Your local
safety regulatory inspector will also inform you [where
appropriate] about work he may be required to perform
on your combustion equipment (e.g. regular checks,
cleaning).
DHW Heating
The DHW is heated up to 122°F (50°C).
Your heating contractor can make further settings for you
during commissioning.
You can change any settings individually at any time
to suit your requirements (see chapter "DHW heating").
Frost Protection
Your boiler and DHW tank are protected against frost.
Power Failure
All data is saved if there is a power failure.
DHW heating can only be selected at the higher control
unit.
Operating Instructions of the higher control unit.
Note: These operating instructions do not apply
in conjunction with multi boiler systems.
To provide you with a better understanding of the
functions of your control unit, the appendix contains
the chapter "Terminology" (see page 18).
General
3