Advertisement
work properly.
Visit our website and download the installation software for MagicTune™ MAC.
Check the following items if there is trouble with the monitor.
1. Check if the power cord and the video cables are properly connected to the computer.
2. Check if the computer beeps more than 3 times when booting.
(If it does, request an after-service for the main board of the computer.)
3. If you installed a new video card or if you assembled the PC, check if the installed the adapter
(video) driver and the monitor driver.
4. Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz.
(Do not exceed 75 Hz when using the maximum resolution.)
5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode,
remove the Display Adapter at the "Control Panel→System→Device Administrator" and then
reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur,
Q & A
Question
How can I change the
frequency?
How can I adjust the resolution?
How can I set the Power Saving
function?
How can I clean the outer
case/LCD Panel?
The edges of the monitor's
transparent case are shown
with white stains.
Self-Test Feature Check
Self-Test Feature Check
Your monitor provides a self test feature that allows you to check whether your monitor is
functioning properly.
your PC or video
graphic card?
contact an authorized service
Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version
of the driver used. (Refer to the computer or the video card
manual for details.)
Windows ME/XP/2000 : Set the resolution at the Control
Panel→Display→Settings.
* Contact the video card manufacturer for details.
Windows ME/XP/2000 : Set the function at BIOS-SETUP of the
computer or the screen saver. (Refer to Windows/Computer
Manual).
Disconnect the power cord and then clean the monitor with a soft
cloth, using either a cleaning solution or plain water.
Do not leave any remains of the detergent nor scratch the case.
Do not allow any water to go inside the monitor.
This phenomenon is the light reflection of the transparent case.
(Prism Effect) The monitor can be seen differently by the angle of
the monitor or the direction or strength of the outside light. (Cover
the top of the transparent case with your fingers. The stain might
be disappeared.)
|
Warning Messages
|
be downloaded
http://www.samsung.com/monitor/magictune.
center.
Answer
Environment
|
Useful Tips
Advertisement
