Toyota LAND CRUISER LC200 Owner's Manual page 125

■ Tire inflation pressure
It may take a few minutes to display the tire inflation pressure after the
●
engine switch is turned to IGNITION ON mode. It may also take a few min-
utes to display the tire inflation pressure after inflation pressure has been
adjusted.
● "---" may be displayed if the tire information cannot be determined due to
unfavorable radio wave conditions.
Tire inflation pressure changes with temperature. The displayed values may
●
also be different from the values measured using a tire pressure gauge.
■ When setting up the display
Stop the vehicle in a safe place, apply the parking brake, and shift the shift
lever to P.
■ Suspension of the settings display
In the following situations, the settings display using the meter control
switches will be suspended.
When a warning message appears on the multi-information display
●
● When the vehicle begins to move
Liquid crystal display
■
Small spots or light spots may appear on the display. This phenomenon is
characteristic of liquid crystal displays, and there is no problem continuing to
use the display.
WARNING
■ Caution for use while driving
For safety, avoid operating the meter control switch while driving as much
as possible, and do not look continuously at the multi-information display
while driving. Stop the vehicle and operate the meter control switch. Failure
to do so may cause a steering wheel operation error, resulting in an unex-
pected accident.
■ Cautions while setting up the display
As the engine needs to be running during setting up the display, ensure that
the vehicle is parked in a place with adequate ventilation. In a closed area
such as a garage, exhaust gases including harmful carbon monoxide (CO)
may collect and enter the vehicle. This may lead to death or a serious
health hazard.
NOTICE
While setting up the display
■
To prevent battery discharge, ensure that the engine is running while setting
up the display features.
LC200_OM_OM60R59W_(WE)
2. Instrument cluster
123
2