Advertisement
1.3
Mounting
XRF-TI is designed for the concealed installation in
the contact profiles of ExpertSystem (see assembly
and mounting instruction).
However it can be wired with other saftey edges
eg. where space is limitted.
1.4
System check
Check the system
by pressing the safety edge
OK?
2
Trouble shooting
2.1
Warning indicator for low battery voltage
Receiver
3x
Beep
Every minute
2.2
Battery change
Order new battery (prepared with connector)
Pull out the PCB (see 1.1.)
Disconnect battery plug and remove battery
Insert new battery, plug in connector
3
Technical data
Input
8.2 kOhm
Battery power
1x Lithium Inorganic 3.6 V
Battery life
Up to 7 years
Operating frequency
868.3 MHz
4
EU Declaration of Conformity
5
WEEE
Devices with this symbol must be treated separately during disposal. This must be done in accordance with the laws of
the respective countries for environmentally sound disposal, processing and recycling of electrical and electronic equipment.
6
Contact
BBC Bircher Smart Access, BBC Bircher AG, Wiesengasse 20, CH-8222 Beringen, www.bircher.com
Designed in Switzerland / Made in China
2
Built-in
(e.g. sliding gate)
The LED flashes when activating the sensor element (pressing the sensing edge)
and flashes again when releasing the sensor element.
Does the door/gate stop when the sensing element is activated?
To find out which
transmitter has low
battery: Press each edge.
Slide in the PCB
Close the cover again
System test mandatory!
Dispose battery acc. to local regulations
Sensing edge
XL
XRF-TI
Sensing
edge
Surface mount
(e.g. industrial door with ClickLine)
OK?
Battery good
Beep
Battery bad
Advertisement
