BBC Bircher RFGate 3.1 370046C Original Operating Instructions

RFGate 3.1
Wireless single channel signal transmission system for safety edges
Original operating instructions
General
Receiver
ON
1
50
4
22
1 Safety instructions
Read these operating instructions thoroughly before putting the
device into operation and keep them for future reference.
Warning: Switch off the operating voltage before working on the
system. Only trained, qualified personnel may perform installation
and startup. The unit may only be repaired by the manufacturer. The
switching unit may only be used to protect against dangers on
crushing and shearing points and on automatic industrial doors and
2 Common application
2.1 Sliding gate
Up to 7 transmitters can be linked with the same receiver
i
DIP-switch
Push button
ON
1
4
22
ON
1 2
22 50
23
Receiver
Transmitter
LED
50 23
ON
1 2
23
4 50
22
gates (intended use). National and international regulations on industrial
door and gate safety must be complied with. Always consider the safety
functions of your application as a whole, never just in relation to one
individual section of the system. The installer is responsible for carrying out
a risk assessment and installing the industrial door system correctly.
Battery life up to 2 years, but it is recommended
i
batteries are changed every 12 months.
LED
Batteries
CR2032
DIP-
switch
ON
1 2
22 50
23
Transmitter
370046C
07/19
Push
button
ON
1 2
4 50
22
23
1