BBC Bircher XRF-T.2 Original Operating Instructions

Transmitter to XRF wireless transmission system
XRF-T.2
EN ORIGINAL OPERATING INSTRUCTIONS
1 Intended use
Monitoring 1 or 2 safety edges and switches on doors and gates, in
combination with a receiver XRF.
2 Safety instructions
• Read these operating instructions thoroughly before putting the
device into operation and keep them for future reference.
• Follow all the recommendations given in this manual to avoid serious
danger to persons.
• Do not use this product other than for its specified application.
• Pay attention to all local relevant electrical safety regulations.
• Only trained and qualified personnel may install and initialize the
device.
• The installer is responsible for testing the system to ensure it meets
all applicable safety standards.
• After accessing the inside of the device, ensure the cover/protection
seal is closed tightly to achieve designated protection rating. The
device must not be used without the cover mounted.
• This device contains batteries. Observe the local regulations for
battery disposal.
3 Installation
3.1 Opening cover
▷ Lift cover at screw end, then slide away.
3.2 Cable routing, strain relief
1. Determine the cable routing.
2. Break out the respective part of the cover if necessary.
3. Punch hole into the grommet.
4. Insert cable (cable Ø: 3.1 – 5.2 mm).
04.2023 © BBC Bircher / bircher.com
1
2
3
4
4.2
22
XRF-T.2
50 23
Either break out a piece of ... or use holes in the base
the cover... plate
3.3 Wiring / set-up
DIP switch setting
▷ Set DIP switch according to sensors (safety edge/ switch). A change
of the DIP switch will be confirmed by a (slightly delayed) flash of the
LED.
Wire cross section: 0.25 – 0.75 mm
ON
1 2 3 4
1 2
8k2 8k2
ON
1 2 3 4
1 2
8k2
1) IN2 is only active when used with dual channel receiver (see receiver manual)
ENGLISH 463831 A
1 Push button
2 LED
3 Battery CR2450N
4 DIP-switch
Use Screwdriver to punch
hole
ON
1 2 3 4
1 2
8k2
ON
1 2 3 4
1 2
1 / 2