BBC Bircher XRF-TI Operating Instructions

XRF-TI
Transmitter to XRF wireless transmission system
Original operating instructions
Intended use: Monitoring safety edges on doors and gates, in combination with a receiver XRF
Saftey instructions
• Read these operating instructions thoroughly before putting the device into
operation and keep them for future reference.
• Do not use this product other than for its specified application.
• Only trained and qualified personnel may install and initialize the device.
• Only authorized factory personnel may perform hardware/software changes or
repairs to the product.
• Failure to follow these safety precautions may cause damage to sensor or objects,
serious personal injury, or death.
• It is the responsibility of the equipment manufacturer to carry out a risk assess-
ment and to install the system, in compliance with applicable local, national and
international regulations, safety standards, codes and laws as well as the
Machinery Directive 2006/42/EC, should this apply.
• Always consider the safety functions of your applications as a whole, never just in
relation to one individual section of the system.
1 Set-up
1.1 Connect battery
 Loosen screw
(at original delivery
shipped in bag with
Philips screw driver #00)
 Carefully pull out
the PCB
 Plug in connector
 LED flashes 5x (confirms battery connected)
 Pairing (1.2) if required
 Slide in the PCB again
 Close the housing, tighten the screw (Philips #00, shipped with unit)
Cable
with
plug
Screw
Delivery state
4.5
LED
Button Battery 3.6. V
• The installer is responsible for testing the system to ensure it meets all applicable
safety standards.
• Safety devices that are classified as Category 2 according to EN ISO 13849-1 must
be tested regularly – at least once per cycle.
• If the safety device is not requested operationally at least once a year, it must be
checked manually by the operator at least once a year.
• Pay attention to all local relevant electrical safety regulations.
• Protect the device with a housing against contamination or aggressive environ-
ments.
• This device contains batteries.
• Observe the local regulations for battery disposal.
• After accessing the inside of the sensor, ensure the cover/protection seal is
closed tightly to achieve designated protection rating.
Battery connected
Note:

Alignment of battery,
position of wire
194
174
4.5
190
PCB
Button

Note:
Position of
red wire
404301E
01/21
Wire
1