Summary of Contents for BBC Bircher Swissdoor RFGate 3.1 370046A
Page 1
370046A 05/18 RFGate Wireless single channel signal transmission system for safety edges Original operating instructions General Receiver Transmitter push Batteries Push button CR2032 button Further transmitters with separate manuals Safety instructions Warning: Switch off the operating voltage before working on the consider the safety functions of your application as a whole, never just in system.
Page 2
Transmitter DIP switch setting according to sensor (safety edge, switch contact) Example: RFGate 3.2.T Sensor connection DIP switch Sensor connection DIP switch Note: IN1 = active IN2 = not used Further instructions see separate transmitter manuals. Receiver Wiring: Power supply and outputs with control Power supply Outputs: Relay contacts are shown unpowered Conductor cross section 0.25 –...
Page 3
Installation sequence set-up Check DIP Install and wire Turn on power switch settings receiver supply Transmitter and receiver and Transmitter: Pairing (Chapter 6): further transmitters must be at insert transmitter with receiver least 0.5 m apart batteries Transmitter: Transmitter: System test: press install wire safety edge on gate...
Page 4
Standard operation Receiver LED indicator Warning indicator for low battery voltage Receiver: 3 beeps every minute LED red LED green Beep Safety Input Battery voltage actuated To find out which transmitter has low battery voltage: Press each edge. A beep indicates the low battery.