Connection And Installation - TP-Link CPE210 Installation Manual

2. Connection and Installation

Connect and mount the CPE and power adapter as shown below. The
LAN0
Ethernet cable length up to 60m
You should prepare an adequate
Ethernet cable to connect the CPE
and the passive PoE adapter.
Shielded CAT5e (or above) cable
with ground wire is recommended
(refer to the next section).
Slide to replace the cover
of the CPE when all
PoE LAN
Connect to a computer,
router or switch.
(Depending on your
intended usage and/or
network topology.)
06