Advertisement
Quick Links
Advertisement
Related Manuals for TP-Link CPE610
Summary of Contents for TP-Link CPE610
- Page 1 Installation Guide Outdoor CPE CPE610...
-
Page 2: Table Of Contents
Contents Overview Package Contents Hardware Overview Hardware Connection Site Consideration Hardware Installation Power Supply Lightning & ESD Protection Software Configuration Logging in to the PharOS Configuration for a Typical Application Antenna Alignment Specifications... -
Page 3: Overview
Overview TP-Link's Pharos series outdoor CPEs are dedicated to outdoor wireless network solutions. This guide is applicable to the product CPE610. Package Contents Pharos CPE Center Reflector Panel Side Reflector Panels (Qty.2) Rear Cover Mounting Bracket Protective Cap (For CPE) -
Page 4: Hardware Overview
Hardware Overview Bottom View Reflector Assembly Securing Arms Bubble Level Rear Cover Mounting Bracket Pole-mount Clamp... - Page 5 Panel Layout On: The wireless function is enabled. On: A device is connected to this port, but there is no activity. Flashing: A device is connected to this port, and is active. On: The CPE is powered on. RESET Press and hold for 5 seconds to reset the CPE to its factory defaults.
-
Page 6: Hardware Connection
Hardware Connection Site Consideration Mounting Height Ensure a clear line of sight between the wireless devices for optimum performance. An elevated location is recommended as obstacles like trees, buildings and large steel structures will weaken the wireless signal. See 'Q2' in 'FAQ' for details about how to calculate the minimum mounting height of the devices. - Page 7 Orientation Install the CPE devices so that they point towards the devices that will receive the signal. You can orient the devices with the help of Google Maps, GPS and some landmarks. The horizontal bandwidth of CPE610 is 6.8°. shenzhen...
-
Page 8: Hardware Installation
Hardware Installation 1. Attach the Side Reflector Panels to the Center Reflector Panel as follows: a. Insert the two mounting studs on the Center Reflector Panel into the large opening of the slots on the Side Reflector Panel. b. Slide the Side Reflector Panel until the mounting studs are positioned over the narrow opening of the slots, and the top edges of the panels should be aligned when done. - Page 9 c. Repeat step a and step b to attach the other Side Reflector Panel. d. (Optional) Attach the Side Reflector Panels to the Center Reflector Panel more securely using four M2.5x8 bolts and nuts (not provided). This is recommended if the CPE device is exposed to extreme weather, such as strong winds.
- Page 10 b. Attach the Rear Cover to the reflector assembly. Press upon the Rear Cover at the four positions marked in the diagram below in sequence until it locks into place. WARNING: To avoid damage, do not place the panels on a flat surface or push down on it.