Step 4: Water Supply Hook-Up - Inter-fab Zoomerang Installation Manual

Table of Contents

Advertisement

WATER SUPPLY HOOK-UP
Your kit contains a length of 1-1/4" hose, a two part plastic fitting, and two plastic clamps.
1. Wet one end of the hose and slide it onto the cone
shaped fitting on the underside of the flume (Fully
enclose the smaller cone). Secure with a plastic
clamp by pinching together the interlocking teeth.
2.
Turn off your filtration system before connecting
the other end of the hose to your pool return
fitting.
3. Remove the collar that secures the directional
"eyeball" fitting in your pool return (inside the
pool). There are many variations of return fittings,
however, the many thread combinations provided
by the two fitting adaptors provided should fit
your pool. Tighten by hand only. You will want
to be able to remove the Zoomerang™
fitting/hose from your wall return fitting when the
Zoomerang™ is not in use.
4. Slide the hose over the lipped flange of the
adaptor fitting until the lip locks into the hose
corrugation. Attach the plastic clamp, but do not
secure too tight. You should be able to swivel the
fitting inside the hose (in order to hand thread or
remove the Zoomerang™ hose/adaptor fitting
combination without tools).
5. Turn on your filtration system and your
Zoomerang™ is ready for action!
8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Zoomerang and is the answer not in the manual?

Questions and answers

Table of Contents