Advertisement
BO RD F LL Installation Instructions
for EDGE aquaBoard
Edge Diving System w/Edge aquaBoard™
w/BOARD FALL
W RNING: IMPORT NT INST LL TION INFORM TION
The installation of this product should be done only by a licensed and professional installer. Installation should
be done strictly in conformance with all local building codes, electrical codes and other building and safety laws
and regulations. Among other things, that your installer should carefully analyze the need to bond the product
to prevent an electrical hazard. Failure to properly install this product could result in a dangerous condition,
including but not limited to electrical or structural hazards. Inter-Fab, Inc. disclaims all liability arising from the
installation and the user assumes all risk associated with the installation.
BF-IM Rev. 7/15 (BBK-BFALL INST)
™
and T7
La Mesa w/Duro-Beam aquaBoard™
8 0 0 . 7 3 7 . 5 3 8 6
™
, DURO-BE M aquaBoard
DIVING SYSTEM
w/BOARD FALL
™
,
Visit inter-fab.com to view
our installation help video.
(Video does NOT replace
installation instructions.)
T7 Diving System w/BOARD FALL
3050 S.
LVERNON W Y
TUCSON,
Z 85713
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Inter-fab EDGE aquaBoard
Summary of Contents for Inter-fab EDGE aquaBoard
- Page 1 Failure to properly install this product could result in a dangerous condition, including but not limited to electrical or structural hazards. Inter-Fab, Inc. disclaims all liability arising from the installation and the user assumes all risk associated with the installation.
- Page 2 The BOARD FALL water feature is available in 2 styles described below. Each style will work on the following: a 6, 8 or 10 foot Duro-Beam aquaBoard™; a 6 or 8 foot Edge aquaBoard™; the T7™ diving board. NOTE: Minimum 10 GPM water supply recommended. Please see detailed installation instructions for dive stand installation information and requirements.
- Page 3 For an Edge aquaBoard™ : Locate the BOARD FALL unit all the way to the back of the BOARD FALL receiver. (Fig. F) Make sure the hose is threaded through the channel as shown. (Fig. G) Using a 1/8” drill bit, drill the 4 holes 1/2”...
- Page 4 Inter-Fab, Inc., and expressly does not cover any labor or reinstallation expenses related to the replacement of any and all Inter-Fab products. This limited warranty shall be the sole and exclusive remedy of irrespective of whether the claims are made in contract, tort, warranty, law, equity or by statue.
Need help?
Do you have a question about the EDGE aquaBoard and is the answer not in the manual?
Questions and answers