Adjustment; Motion Control Lever; Hst Neutral; Maximum Speed (Forward) - Kubota ZD1211-AU Operator's Manual

MOTION CONTROL LEVER

ADJUSTMENT

MOTION CONTROL LEVER
WARNING
To avoid serious injury or death:
• Park the machine on a firm and level surface.
• If it is necessary to run the engine indoors, use
a gas tight exhaust pipe extension to remove
the fumes.
• Always try to work in a well-ventilated area.
• Lift up and secure with jack stands or by
blocking the rear of the machine. Do not run the
machine while adjusting.
Remove the rear wheels.
• Do not make only one of the following
adjustments (except
LEVER ALIGNMENT").
They are interlinked.
• If you feel you are unable to make the following
adjustments correctly and safely, contact your
local KUBOTA Dealer.
Details regarding motion control lever alignment can be
found in a different section.
(See Motion control lever alignment on page 88.)
IMPORTANT :
• Right and left motion control levers can be
adjusted independently.

1. HST neutral

1. Lift up and secure with jack stands or by blocking
the rear of the machine frame.
2. Remove both rear wheels.
3. Set the engine speed to maximum.
4. Place the motion control lever in the "NEUTRAL
LOCK" position.
5. After forward and backward operation, tighten the
guide control at the position when wheel axis stops.
6. Adjust the rod length (L) of the damper 28 to 32 mm
(1.1 to 1.3 in.) and tighten.
ZD1211,ZD1221
"MOTION CONTROL
(1) Guide control
(2) Motion control lever
(1) Damper

2. Maximum speed (forward)

Consult your local KUBOTA Dealer for this service.
3. Adjusting the motion control lever
operating strength
The strength required to move the motion control levers
can be adjusted to 3 levels depending on operator
preference.
NOTE :
• Adjust the dampers after adjusting HST neutral.
• Adjusting the motion control lever strength will
affect the maneuverability.
• For adjustment of LH and RH, use the same
hole location.
ADJUSTMENT
(L) 28 to 32 mm (1.1 to 1.3 in.)
87