Snow Performance Boost Cooler Manual page 3

Step 2 Tank Install
OPTIONAL: If desired you can use the stock windshield washer fluid tank as the tank for your water-
meth system. Simply drill and tap a 3/8" NPT hole in desired feed spot for system and install the 3/8"
NPT fitting into the tank using E-6000 sealant on threads/around area.
If you do not want to use the OEM windshield washer fluid tank or 3qt tank, upgrades exist to move your
tank to the trunk (See Part# SNO-40012 or SNO-40012-BRD) and other larger trunk mount tank options
(See Part# SNO-40014 or SNO-40014-BRD)
Braided Line Kits Only:
Step 1: Install 3/8" NPT to ¼" Quick Connect fitting or 3/8" NPT to 4AN Elbow fitting into the bottom of
the reservoir using E6000® sealant on the threads.
Step 2: After allowing the thread sealant to dry, fill reservoir with water and check for leaks around tank
fitting and level sensor. If leak occurs use E6000® sealant.
Step 3: Install the 3qt. tank with four (4) #8x1&1/2" self-tapping screws and four (4) #8 washers
(supplied) in desired mounting location. Typical placement is any void area inside the engine bay.
CAUTION
:
body it is essential to use a solenoid upgrade (Part # SNO-40060 / SNO-40060-BRD). Do not operate your rear
mount reservoir equipped vehicle without an anti-siphon solenoid installed.
The reservoir should be installed above the pump, but below the nozzle. This keeps the
pump primed and avoids fluid leaking into nozzle when not in use
To avoid gravity feeding of fluid with rear mount reservoirs or injection points past the throttle
Page | 3