Step 7 Last Step - Snow Performance Boost Cooler Manual

For most setups the value that is used ranges from 0.5 to 3, depending on where the RPM signal is obtained
from.
Enter an initial pulses/revolution value (start at 0.5) and click Write All (Always use Write All, not Write)
Next, start the car and Click Live Updates (and ensure the indicator to the left of it turns Green)
Next Click on the Live View Tab to view RPM readings reported by the controller
If the RPM reading on the Live View Tab doesn't match the reading on the dash, go back to the Basic Config
Tab, adjust the value with the up/down arrows
And click Write All to apply the new value to the unit. Check the Live View tab again and repeat until the
readings match. Turn off the engine.

Step 7 Last Step

Click Read one more time to ensure the software imports the current controller parameters.
Click Save As and save this starting calibration file to your PC so you can go back to it.
General Notes
Always Click Read every time you connect the controller.
Page | 14