GE AKR-30 Series Maintenance Manual page 237

The remote fault indication switch leads are brought
out the bottom of the MicroVersaTrip program mer as
shown in Fig. 78. This switch lead harness is plugged
into the mating connector on the breaker, see Fig. 79.
The switch leads are brought out from the breaker
through the Programmer Secondary Disconnect shown
in Fig. The zone selective interlocking fu nction wir­
80.
ing is also brought out through this disconnect. See
Figs. 95 and 96 for the remote fault indication and zone
selective interlocking cable d iagrams.
· • · .
"""' ­
"'"
•
FIG. 78 M I C ROVERSATRIP W/REMOTE
FAU LT I N D I CATI O N HARN ESS
FIG. PROGRAMMER
79
SECONDARY CONNECTOR
FIG. 80
REMOTE FAU LT I N DICATOR
DISCONNECT
1 2. 1 .3 M ICROVERSATRIP™ I N STALLATION
The programmer mounts to the upper left of t h e breaker
as shown in Fig. It mounts to the bracket assembly
8 1 .
shown i n Fig. Referring to Fig.
82.
with the holes on either side of the prog rammer con nector.
They provide the necessary alig nment for the connector
engagement . The locking lever engages with the pin which
i s assembled t o the program mer frame and secures the pro­
grammer to the mounting bracket
There are two prog rammer mounting designs in use. The
d i fference in the designs is in the operat ion of the l ocking
lever, see Fig.
82.
I nstallation using each design is as follows:
a. I n sert the gu ide p i ns i nto the holes and push on the pro­
gram mer, e n gag i n g the con nectors.
b. Orig i nal design-push in the locking lever, securing the
programmer.
Later design - the locking lever i s released, securing
the
programmer.
c. Verify t hat the locking lever did engage the programmer
pin.
d. Connect remote fault ind icat ion harness, if eq u i pped,
see Fig.
80.
To remove the programmer:
a. Disconnect the remote fault i ndication harness, if
eq uipped.
b. Original designs - push i n l ocking lever, which w i l l
release the programmer p i n . W h i l e holding the locking lever
i n , remove the programmer.
c. Later design - p u l l out locking lever, which w i l l release
the programmer pin. Remove the programmer.
the gu ide pins mate
82,
59