Individual Foul Panel Installation; Opening An F6 Individual Foul Panel - Bodet 8000 Installation Manual

7. INDIVIDUAL FOUL PANEL INSTALLATION

7.1 Opening an F6 individual foul panel

This chapter presents the installation method for an F6 individual foul panel in the 8000 range. The mounting
principle is identical for F10 and FS10 individual foul panels
Reminder: the additional module must be assembled with the main scoreboard on the ground.
1) On the ground, remove the metal covers to access the attachment holes. Loosen all screws on the panel as
follows:
Remove the sheet metal front plate taking care to not snatch away the ribbon cables. Three metal covers in
models F10 and FS10.
Fully loosen the screws on the
front panel
2) Lift up the panel to extract it from the keyhole slot. Shift the panel to the left or right, repositioning it in the keyhole
slots.
3) Disconnect the grounding connection at the bottom of the module and the ribbon cables from the electronic cards
(the cables are labelled to avoid error at reconnection time, however make sure to identify them). Example with
matrices on the 3rd part of the module (lower part):
16
3
0 8
Loosen these three screws by a
few millimetres only.
0
8
3