Cisco 6160 Installation Procedures Manual page 21

Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Figure 4-12 Cabling for T1 or T1 IMA Subtended Network Configuration
Subtended node
chassis 1
Subtended node
chassis 2
Subtended node
chassis 3
Connect the other end of the cable used in
Step 3
DS3/2DS3+8xT1 IMA I/O card located on the subtended node chassis backplane.
Step 4 Repeat
Note
OL-2190-02 B0
Step 1 through Step 3 for each subtending host chassis.
Verify that the RJ-48 cable pinouts connect transmit to receive and receive to transmit. For more
information on the RJ-48c receptacle pinouts, see the
I/O Card RJ-48c Receptacles" section on page
Subtending host
chassis
Subtended node
chassis 4
Subtended node
chassis 5
Step 2 to one of the RJ-48c receptacles on the
"Pinouts for the DS3/2DS3+8xT1 IMA
C-4.
Cisco 6160 Hardware Installation Guide
Installation Procedures
Subtended node
chassis 6
Subtended node
chassis 7
Subtended node
chassis 8
4-21