Cisco 6160 Installation Procedures Manual page 23
Without a pots splitter configuration
Hide thumbs
Also See for 6160:
- Quick reference manual (38 pages) ,
- Hardware installation manual (21 pages) ,
- Installation and replacement notes (18 pages)
Advertisement
Chapter 4
Installing a Cisco 6160 Without a POTS Splitter Configuration
4.2.11.2 OC-3c Network Connections
Complete the following steps to connect the OC-3c network connections:
Warning
Do not stare into the beam or view it directly with optical instruments.
Step 1
Verify that the OC-3c/OC-3c or OC-3c/2DS3 NI-2 card is installed in slot 10 (or slot 11, if a secondary
NI-2 card is being installed for redundancy) of the Cisco 6160 chassis to ensure that the OC-3c NI-2
connections are active.
Note
Attach the receive cable from the ATM switch to the TRNK 1 TX optical interface connector on the
Step 2
OC-3c/OC-3c or OC-3c/2DS3 NI-2 card.
Note
Attach the transmit cable from the ATM switch to the TRNK 1 RX optical interface connector on the
Step 3
OC-3c/OC-3c or OC-3c/2DS3 NI-2 card.
To establish APS link redundancy repeat
Step 4
OC-3c/2DS3 NI-2 card.
Reboot the system to reassociate the system MAC address.
Step 5
Repeat
Step 6
4.2.11.3 T1 or T1 IMA Network Connections
Complete the following steps to connect the T1 or T1 IMA network connections:
See the
Note
network connection.
Verify that you have a DS3+T1/E1 IMA NI-2 card is installed in slot 10 (or slot 11, if a secondary NI-2
Step 1
card is installed for redundancy) and the DS3/2DS3+8xT1 IMA I/O card is installed on the chassis
backplane.
Note
Step 2
Connect one end of an RJ-48 cable to one of the RJ-48c receptacles on the DS3/2DS3+8xT1 IMA I/O
card. If you have a subtended network configuration installed, this connection must be made from the
DS3/2DS3+8xT1 IMA I/O card in the subtending host chassis.
OL-2190-02 B0
See the
"Redundancy in Subtended Configurations" section on page 1-42
about redundancy configurations.
See
Figure 1-16
or
Figure 1-17
Step 1
through
Step 5
for each Cisco 6160 chassis being installed.
"IMA Configuration" section on page 1-5
See the
"Redundancy in Subtended Configurations" section on page 1-42
about redundant configurations.
or OC-3c connector locations.
Step 2
and
Step 3
for a secondary OC-3c/OC-3c or
for more information on how to configure an IMA
Cisco 6160 Hardware Installation Guide
Installation Procedures
for more information
for more information
4-23
Advertisement
