Cisco 6160 Installation Procedures Manual page 31

Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Installation Procedures
!
interface ATM21/0
shutdown
no ip address
!
interface ATM21/1
shutdown
no ip address
!
interface ATM21/2
shutdown
no ip address
!
interface ATM21/3
shutdown
no ip address
!
interface ATM26/0
no ip address
!
interface ATM26/1
no ip address
!
interface ATM26/2
no ip address
!
interface ATM26/3
no ip address
!
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
To configure your system, refer to the appropriate software or network management
Note
configuration guides.
Cisco 6160 Hardware Installation Guide
4-31
OL-2190-02 B0