Cisco 6160 Installation Procedures Manual page 18

Installation Procedures
Figure 4-10
Figure 4-10 Cabling for DS3 Subtended Network Configuration
TX
Network
PORT 1
RX
Transmit
TX
Receive PORT 2
RX
Transmit
TX
Receive
PORT 3
RX
Transmit
TX
PORT 1
Receive
RX
TX
PORT 2
RX
TX
PORT 3
RX
On the first subtended node chassis backplane, attach the end of the coaxial cable used in
Step 3
RX BNC for DS3 Port 1 on the I/O card.
Step 4 On the subtending host chassis backplane, attach one end of a coaxial cable to the RX BNC connector
for DS3 Port 2 on the I/O card.
Step 5 On the first subtended node chassis backplane, attach the end of the coaxial cable used in
TX BNC connector for DS3 Port 1 on the I/O card.
Step 6 On the subtending host chassis backplane, attach one end of a coaxial cable to the TX BNC connector
for DS3 Port 3 on the I/O card.
On the first subtended node chassis backplane, attach the end of the coaxial cable used in
Step 7
RX BNC for DS3 Port 1 on the I/O card.
On the subtending host chassis backplane, attach one end of a coaxial cable to the RX BNC connector
Step 8
for DS3 Port 3 on the I/O card.
Cisco 6160 Hardware Installation Guide
4-18
shows the cabling for a DS3 subtended network configuration.
Subtending
host chassis
P1
P2
P3
P4
P5
Transmit
Receive
1st subtended
node chassis
P1
P2
P3
P4
P5
Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
2nd subtended
TX
node chassis
PORT 1
RX
TX
PORT 2
RX
TX
PORT 3
RX
P1
P2
P3
P4
P5
Step 2 to the
Step 4 to the
Step 6 to the
OL-2190-02 B0