Introduction; Installation Process Overview; Controls And Indicators; Status Leds - Johnson Controls Tyco HSM2HOST Installation Manual

2-way wireless transceiver

Hide thumbs Also See for Tyco HSM2HOST:

Table of Contents

HSM2HOST Installation Manual

Introduction

The HSM2HOSTx two-way wireless transceiver adds wireless capability to alarm controllers, mod-

els HS2016, HS2032, HS2064, HS2128, HS3248, HS3128, HS3032.The HSM2HOST receives sig-

nals from wireless zones and wireless keys, and provides information to the alarm controller it is

connected to. This manual describes how to install, program and maintain the HSM2HOST. Note

that only one HSM2HOST or one RFK keypad can be enrolled on the alarm system.

Before installing:

1. Plan the placement and wiring of the security system (see system installation manual).

2. Install the control panel and optional modules.

3. Temporarily mount all wireless devices in the intended location.

To install and set up the HSM2HOST and wireless devices:

1. Temporarily mount and wire the HSM2HOST module ("Temporary mounting requirements"

on page 9).

2. Enroll the HSM2HOST and first wireless keypad ("Enrolling The HSM2HOST" on page 10).

3. Check the location for RF interference levels ("[804][801] RF Jam Detect" on page 13).

4. Enroll wireless devices ("[804][000] Enrolling wireless devices" on page 12).

5. Complete zone and other programming on the system ("Wireless device setup and pro-

gramming" on page 12).

6. Test the placement of all the wireless devices ("[904] Placement testing of wireless devices"

on page 17).

7. Permanently mount the HSM2HOST and wireless devices ("Permanently mounting the

HSM2HOST and wireless devices" on page 10).

The LEDs on the front of the HSM2HOST provide feedback regarding the installation, operation

and troubleshooting of the unit. The LEDs function as follows:

Table of Contents

Do you have a question about the Tyco HSM2HOST and is the answer not in the manual?