Enrolling The Hsm2Host; Permanently Mounting The Hsm2Host And Wireless Devices - Johnson Controls Tyco HSM2HOST Installation Manual

Enrolling The HSM2HOST

The enrollment of a HSM2HOST to an alarm panel is dependent on the system configuration.
Enrolling the HSM2HOST without a hardwired keypad
To enroll the HSM2HOST without a hardwired keypad, complete the following steps:
1. Turn on the wireless keypad by connecting the power source.
2. Simultaneously press [*] and [1] on the keypad.
The system can take up to 30 seconds to complete the enrollment
Enrolling the HSM2HOST with an enrolled hardwired keypad
To enroll the HSM2HOST with an enrolled hardwired keypad, complete the following steps:
1. On the enrolled keypad, enter Installer Programming section [902][000] (Auto Enroll All Mod-
ules).
2. When the system prompts you, press [*].
Enrolling the HSM2HOST with only unenrolled hardwired keypads
To enroll the HSM2HOST with only unenrolled hardwired keypad(s), complete the following steps:
1. Enroll only one hardwired keypad onto the system by pressing any key on the keypad.
2. Enter Installer Programming section [902][000](Auto Enroll All Modules).
3. When the system prompts you, press [*] to enroll the HSM2HOST and all other keypads or
modules on the system.

Permanently mounting the HSM2HOST and wireless devices

Once you identify a suitable location to permanently mount the HSM2HOST and wireless devices,
complete the following steps:
1. Pull the Corbus wires through the holes at the back of the HSM2HOST cabinet.
2. Using a screwdriver, securely mount the HSM2HOST cabinet of to the wall using the three
screw supplied. For more information, see Figure 2.
3. To install the wall tamper, securely attach the breakaway wall tamper bracket to the wall using
the screws supplied.
4. Install the wireless devices. For more information, refer to the device's Installation Guide.
10
Enrolling The HSM2HOST