1. Technical data Area of application: For the creation of an electrical connection by means of compression Scope of delivery: Crimping head in a black plastic case, without dies. Oil type: ISO class viscosity 15 Safety: The tool is fitted with a safety value that has been set at the factory. Structure: The working head can be rotated by 180°...
Page 4
3.2. Start • Bring the tool to the working position. • Select the appropriate pressing dies for the connection to be pressed. • Insert the pressing dies in the tool head. • Feed the conductor into the connector. • Place the connector between the two pressing dies. 3.3.
If the tool still does not work, send the tool to the HAUPA service centre for fine tuning by our specialist staff. Do not send accessories as these are not necessary.
• Refilling or filling with oil • Use only the oil name in section 1 or purchase from the HAUPA service centre (Art. 216254). • Never use old oil. • The oil must be clean and may not contain contamination.
Page 7
4) Tool type. 5) Serial number of the tool. The guarantee is voided if you use parts that are not original replacement parts from HAUPA. … convincing solutions Germany: HAUPA GmbH & Co. KG, Königstraße 165-169, D - 42853 Remscheid.