Cleaning The Filters; Cleaning The Brushroll - Shark DuoClean Powered Lift-Away AX950UK Series Instructions Manual

CLEANING THE FILTERS

STEP 1
PRE-MOTOR
FOAM FILTER
FILTER FRAME
FELT FILTER
1 Pre-Motor
(foam and felt):
With the dust cup
removed, take out the
foam and felt filters, and
rinse with water. Tap loose
dirt off filters between
washes as needed.
2 Post-Motor (HEPA):
To access the HEPA and
foam filter, reach under
the grill, pull the latch
forward, and pull the grill
away from the vacuum.
17
0800 862 0453
STEP 2
POST-MOTOR
HEPA
STEP 3
POST-MOTOR
HEPA PRE-
HEPA
Remove the filter assembly,
3
then remove the pre-HEPA
filter from the assembly.
Rinse both HEPA filter and
pre-HEPA filter and allow
to air dry completely before
replacing. Hand wash only.
MAINTENANCE - continued
TIP: You can also check
for blockages in the hose
and tubes. Just remove
the floor nozzle, dust cup,
and hose and shine a
flashlight in the openings.

CLEANING THE BRUSHROLL

To open the brushroll garage, slide both release buttons
1
on the floor nozzle away from you, towards the back of the
nozzle, then lift off the brushroll garage lid.
2 To remove any string, hair, or debris that may be wrapped
around the brushroll, use scissors to cut along the groove in
the brushroll.
3 To close the brushroll garage, insert the tabs on top of lid
into the slots in the nozzle, then push down on both sides
of lid until it clicks securely into place. If Brushroll Indicator
Light isn't green and headlights are flashing, check again
that both sides of lid are locked in place.
STEP 1 STEP 2
s h a r kc l e a n . e u
18