Advertisement
»
»
INSTALLATION INSTRUCTIONS
NOTICE DE MONTAGE
MOUNTING RIGID DESCENDING PIPES
> >
63
Vacuum point rigid
fittings
65
Union under the
skimmer
67
Return fitting rigid
descending pipe
60
/ OCTO & OCTO +
/ OCTO & OCTO +
64
66
Rigid descending
pipe below the
skimmer
68
Jetzt Angebot anfordern auf www.poolseller.de
Jetzt Angebot anfordern auf www.poolseller.de
threading of the elbows on the rigid
descending pipes C&C' that you will find
in the Accessories skin pack, then screw
them onto the outside of the throughwall
flanges (return fitting and vacuum point).
Don't forget to use the o-rings provided in
the Pool Fittings skin pack.
seal.
of the rigid descending pipe C onto the
elbow.
Elbow on return
fitting throughwall
flange.
skimmers. Do not forget to wrap Teflon
around both threadings.
fittings on under the skimmers. Cut the
pipes according to the marking that
corresponds to the height of the pool.
Chamfer the edge of the cut slightly to
facilitate insertion of the pipe into the
compression fitting. Check that the pipe is
fully inserted then tighten the green ring
to create a water tight seal.
the return elbow. Do not forget to check
that the o-rings are in place.
vacuum point (as described previously
according to the height of your pool), and
mount it as shown in image 66.
Vacuum
fitting rigid
descending
pipe
Wrap Teflon 4 or 5 times around the
Tighten by hand to avoid crushing the
Next, screw the upper barrel union
Screw the unions, J, under the
Screw the heads of the compression
Screw the rigid descending pipe C onto
Cut the rigid descending pipe on the
Advertisement
