Table of Contents
Advertisement
Fig. 1
Step 1: Trowel shown with handle separate. (Fig. 1)
Fig. 3
Fig. 5
Step 4: Lift and install handle to position using the supplied four sets of lockwashers and nuts.
Do not torque greater than 18ft-lb. At the yoke; tighten the locknut for pitch control cable (Fig. 6).
If the cable is too loose or tight, the pitch control range position can be moved by changing the
position of the stop screw (Fig. 5). The factory default is the middle position. Turn the pitch control
knob completely clockwise and check for maximum pitch possible. This is possible when the clear-
ance between the yoke and underside of the gearbox is enough to pass a business card through.
375 ANNAGEM BLVD., MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
200 COMMERCE DRIVE, FREEHOLD, NEW JERSEY, USA, 07728, 732-566-5400 FAX 732-566-5444
WALK-BEHIND TROWEL INSTRUCTION MANUAL
SETUP PROCEDURE
Step 3: Install pitch control cable to yoke and install locknut loosely
(Fig. 4). If needed, turn pitch control knob counter-clockwise until the
stop screw is at the lowest position (Fig. 5).
Fig. 2
Step 2: Lay handle on ring to prepare for assembly.
(Fig. 2 and 3)
Fig. 4
Fig. 6
10
CREATED: 07/04
REVISED: 07/14
Advertisement
Table of Contents
