Page 2
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL SAFETY PRECAUTIONS DANGER EXPLOSION HAZARD Never operate the machine in an explosive atmosphere, near combustible materials or where ventilation does not clear exhaust fumes. WARNING BURN HAZARD Never come into contact with the engine or muffler when engine is operating or shortly after it is turned off.
However, when in need of parts or major service be sure to see your Bartell dealer. For your convenience we have provided this space to record relevant data about your ride-on Trowel.
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL Each After 1.5 Each 3 Each 6 Each 9 Each 12 Routine Service months months months months months Intervals 50 hrs 100 hrs 200 hrs 300 hrs 400 hrs General Inspection: Operation of lights Check Battery Clean &...
Page 7
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL Each After 1.5 Each 3 Each 6 Each 9 Each 12 months months months months months Routine Service Intervals - Continued - 50 hrs 100 hrs 200 hrs 300 hrs 400 hrs Drive Train: Bearings...
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL FOREWORD ASSEMBLY INSTRUCTIONS It is important that the following be read carefully in Your new Bartell Ride-On Trowel has been shipped to order that the operational performance of the Bartell you partially disassembled. To prepare for operation use RIDE-ON...
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL 4. SEAT ASSEMBLY 3. TO STOP ENGINE Remove protective wrapping from seat. The seat is a) Bring throttle to low idle, wait a few seconds. now ready to secure to the frame using included b) Remove left foot from dead-man safety switch.
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL 5. FLOAT/TROWEL PITCH SETTING 7. TRANSPORTER USE Once you are familiar with the steering functions on a flat floor, you are ready to combine the steering CAUTION: with float/trowel pitch settings to produce the finish The transporter is designed to be used on the job you require.
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL 4. BELT CHANGE PROCEDURE 3. GEARBOX Remove belt cover from the machine to expose the Check the oil level sight plugs on both gearboxes drive components. To change the primary drive belt, daily to ensure the oil is half way on the site glass.
Page 12
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL TROWEL ARM ADJUSTMENT FIXTURE PART #20801 Unit 36” (TS88) 1) 10411 – Trowel arm 2) 10817 – Lift lever 3) 10808 – Jam nut 4) 10809 – Set screw 5) 10824 – Block top 6) 10507 – Bolt 7) 10816 –...
BXR830 RIDE-ON TROWEL INSTRUCTION MANUAL TROUBLESHOOTING WON’T START BELT WEARING RAPIDLY Throttle fully open ¥ ¥ Belt adjusted improperly Hand lever wire broken ¥ ¥ Pulley out of alignment No gas ¥ ¥ Wrong belt/defective belt Dirty gas ¥ ¥...
Under no circumstances shall Bartell Morrison Inc. be liable for any additional or exceptional costs beyond the cost to repair or replace the defective portion of the equipment. Bartell Morrison Inc. shall not be held accountable for; costs associated with travel to inspect or repair defective equipment, costs for transporting defective equipment to or from an authorized repair facility, costs incurred to repair or replace the defective equipment at any facility other than one authorized by Bartell Morrison Inc., or ancillary...
SAMPLE OF CE CERTIFICATE Declaration of Conformity / Certificat de conformité / Gelijkvormigheids certificaat Declaración de Conformidad/Declaração de Conformidade/Dichiarazione Di Conformita Bartell Morrison Inc. 31 SunPac Blvd Brampton, Ontario, Canada L6S 5P6 Tel: 905-458-5455 Fax: 905-458-5484 Declare under our sole responsibility that the product to which this declaration relates is in conformity with the following standard(s) or other normative documents.
L’originale dossier tecnico di construzione è conservato presso: Facsimile: 905-458-5484 The authorized representative is: Mr. Steve Adam Le représentant autorisé est: International Sales Manager Gemachtigd vertegenwoordiger is: C/o Bartell Morrison Europe La representación autorizada es: Nijverheidsstraat 11 O representante autorizado é: 1840 Londerzeel Il rappresentate autorizzato: Belgium...
Need help?
Do you have a question about the BXR830 and is the answer not in the manual?
Questions and answers