Table of Contents
Advertisement
Once the mounting base is installed, attach the alarm by twisting clock-
wise until it clicks. If the battery is either missing or inserted incorrectly, or
the switch is in 'Learn Mode', the heat alarm will not be able to click into
the mounting base.
CLICK THE HEAT ALARM
FIRMLY INTO THE BASE
TO LOCK
6.
TEST FUNCTION:
After installation, and at least once per quarter, test all of your alarms to
ensure they are operating correctly and are within range of each other.
It is recommended to check visually every week if the LED flashes correctly
(every 48sec.)
Press the test button on any alarm for at least 6.5 seconds (count 2 sets of 3 sound
sweeps). This will send out a test signal from the alarm; all other connected
alarms should receive the signal within a short time. The alarms will emit a
short beep and the LED will flash every 8 seconds for 2 minutes.
NOTE: Test function also allows to send a depleted RF signal to ensure an optimal
operation in normal conditions.
18
Advertisement
Table of Contents
