Enhanced Monitor Configuration Switch; Figure 2-12, Setting The Enhanced Monitoring System Configuration Switch - Racal Instruments 1261B User Manual

Enhanced
Monitor
Configuration
Switch

Figure 2-12, Setting the Enhanced Monitoring System Configuration Switch

Configuring The 1261B 2-18
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Omit this procedure if your mainframe is not equipped with the
Enhanced Monitoring System (EMS).
Perform this procedure only if factory default setting
is incompatible with your application. See Figure 2-12
for default setting.
Ensure that J400 AC Input is disconnected before
removing or replacing the System Monitoring (EMS)
module. Possible damage to the module could result.
1. Remove the EMS module. See Removal
2. Configure
3. Replace the EMS module. See Removal
1261B User Manual
NOTE
WARNING
and Replacement in Chapter 7.
Position "1" enables changes.
SW1 located
component side of the EMS module.
and Replacement in Chapter 7
Racal Instruments Ó 1995
on the
Revised 5/21/01