AN1003 - How to program a TOUCHLOCK compact
Paxton Access
Programming TOUCHLOCK compacts
TOUCHLOCK compact keypads are programmed using a programming menu that is accessed by the
system administrator using a programming code, defined when the keypad is initialised.
Initialising the keypad
When the system is powered up for the first time the keypad will bleep 3 times a second. This
indicates that the keypad is waiting to be initialised. The red LED will be steady, the amber LED will
flash slowly and the green LED will flash quickly.
Press the bell button (The unit will stop bleeping)
Enter your chosen 6 digit programming code* and press the bell button (The green LED will flash faster still)
Confirm your programming code by entering the same 6 digit code and pressing the bell button (The green
LED goes out and the unit will acknowledge that the programming code has been accepted by bleeping
twice after a short pause. All the LED's are now on)
*Note that the programming code SHOULD NOT contain the sequence of numbers 1234, as this is the default user code
The keypad should now work with the user code 1234. The programming code you just entered will
now let you into programming mode, where additional alterations can be made.
Programming the keypad
How do I enter the programming mode? - To change any of the settings on the keypad you must
enter the programming menu. To do this, simply enter the 6 digit programming code. The keypad
will beep twice and the green LED will flash.
How can I enter multiple user codes? - To use multiple user codes "multi user mode" must be
entered. First enter programming mode, hold down "2" for 3 seconds then press "6" . The keypad is
now able to accept multiple user codes. In this mode, old codes must be deleted when they are no
longer required.
How can I change a user code? - If the keypad is in single user mode a new code will replace the
old one. In multi user mode a new code can be added or old ones deleted. First enter programming
mode, hold down "8" for 3 seconds. Enter the new user code followed by the bell button, enter the
new code again to confirm again followed by the bell. A final key press defines what type of code
the new one will be, "2" to delete the code, "4" to enter the code as a normal code, "6" for a toggle
code and "8" for a duress code.
How can I change the programming code? - Enter programming mode and hold down "6" for
3 seconds. Enter the new programming code followed by the bell button. Re-enter the new code
to confirm the change followed by the bell button. The new code is now programmed; the old
programming code will no longer work.
Compact
AN1003 - How to program a TOUCHLOCK compact
18/06/2008
1