Advertisement
2
Using a 22 mm wrench act on one of the end
elements (2) or (3) and adjust the length (with the
bar installed, without removing it from the arms
and without unscrewing the lock nuts) until reach-
ing the desired position (new distance between
centers).
3
Once this length is reached, tighten the ring
nut (1) again by means of a 22 mm wrench with a
tightening torque of 40 [Nm] (29.52 [lb ∙ ft]) using a
second wrench on the end element (2).
page 12
of 19 -
TIE BAR A95
Installation and Maintenance Manual
2
3
2
1
Advertisement
