Advertisement
5
Using a 22 mm wrench act on one of the end
elements (6) or (7) and carry out the fine adjust-
ment of the bar length.
6
Once the fine adjustment has been carried out, tighten the
ring nut (8) using a 22 mm wrench with a tightening torque
of 40 [Nm] (29.52 [lb ∙ ft]) by means of a second wrench on
the end element ( 7).
WARNING
Check if the engine can also tilt independently and in different
steering positions.
CAUTION
In no event shall the bar and/or its connections constitute a
limitation to the steering allowed by the installed steering
system and to the lifting of the engines.
2.3 Adjustment of the distance between centers with installed bar
If during the use of the boat it is necessary to vary the distance between centers of the engines (i.e. the angle of
divergence or convergence), proceed as follows.
WARNING
Before carrying out the following operations, it is mandatory to turn off the engines and operate in safe conditions.
1
Loosen the ring nut (1) by means of a 22 mm
wrench holding it still with a second wrench on the
end element (2).
Installation and Maintenance Manual
7
6
7
2
-
TIE BAR A95
8
1
page 11
of 19
Advertisement
