Advertisement
3
Adjust the length of the bar by screwing and unscrewing the two ball joints of the same size.
CENTERS OF THE ENGINES
WARNING
WHEN MAXIMUM EXTENSION IS REACHED, DO NOT FORCE THE UNSCREWING BECAUSE THIS CAN DAMAGE
THE PRODUCT.
NOTICE
Be careful not to damage the exposed thread: dents on the thread cause seizure.
4
Assemble extension arm (1) on the cylinder
body (2) by means of the supplied wrenches (3).
Tighten the screws with a 76[Nm] (56 [lb∙ft]) tight-
ening torque by means of a 14mm wrench.
DANGER
Screw loosening causes deterioration and con-
sequent ineffectiveness of the pre-applied thread
locker. If the screws are loosened, they must be
replaced.
5
Position the safety washer (4) and fasten it with
screw (5) applying some strong Loctite 270 with a
3[Nm] (2 [lb∙ft]) tightening torque.
DANGER
The non-use of screw (5) and of safety washer (4)
results in dangers to things and injury of people.
page 10
of 19 -
TIE BAR A95
DISTANCE BETWEEN
26''
27''
28''
29''
30''
31''
32''
34
36
37.5''
Installation and Maintenance Manual
APPROXIMATE LENGTH OF THE BAR
455 mm (18'')
480 mm (19'')
508 mm (20'')
533 mm (21'')
787 mm (22'')
584 mm (23'')
608 mm (24'')
660 mm (26'')
711 mm (28'')
747 mm (29.5 '')
L
3
2
5
4
1
Advertisement
