Titan TA750 Instruction Manual page 57

Fault
Strap tension isn't enough.
Plastic strap tears when being
tensioned.
Feed wheel slips trough.
Seizing signs on plastic strap.
The plastic strap tensioned is
bent on its side, it is not proper
within the strap guidance's; the
seal is not in the centre.
During the tensioning operation
the tool moves forward.
After the tensioning operation
the tool moves backward and
the plastic strap loosens.
TA750
(0001)
Cause
Strap tension not set correctly.
Li-Ion battery insufficiently
charged.
Tension motor (505), gear unit
(90) or circuit board (120)
defective or worn.
Strap tension setting too high.
Edges of packing item too
sharp.
Use of inappropriate plastic
strap.
Feed wheel (91) and/or gripper
plate (6) were polluted. Gearing
is worn or defective.
Strap tension setting too high.
Use of inappropriate plastic
strap.
Ambient temperature too high.
Gap between feed wheel (91)
and gripper plate (6) is too
small.
Use of inappropriate plastic
strap.
Strap tension not set correctly.
Strap dimension and strap
guidance's does not fit together.
Use of inappropriate plastic
strap.
Strap tension not set correctly.
Gripper plate (6) were polluted,
gearing is worn or defective.
Use of inappropriate plastic
strap.
Free wheel (81) or drawn cup
roller (84), and/or plastic strap
holding unit were defective.
H TA750 EU 46/17
Remedy
Check value set on the operator
panel and correct, if required.
Check charge of Li-Ion battery and
recharge it.
Check tension motor (505), gear
unit (90) and circuit board (120) for
damage (visual inspection), contact
TITAN service dept.
Correct strap tension value set on
the operator panel downward.
If sharp packing item edges exist,
use an edge saver.
Use appropriate plastic strap, ask
your TITAN – Adviser for advice.
Clean feed wheel (91) and/or
gripper plate (6). Check gearing,
replace when damage becomes
visible.
Correct strap tension value set on
the operator panel if necessary.
Use appropriate plastic strap, ask
your TITAN – Adviser for advice.
Reduce the ambient temperature.
Increase the gap between feed
wheel (91) and gripper plate (6), ask
your TITAN – Adviser for advice.
Use appropriate plastic strap, ask
your TITAN – Adviser for advice.
Check value set on the operator
panel and correct, if required.
Check strap dimension and strap
guidance's, they must fit together, if
required replace the strap
guidance's or use other strap.
Use appropriate plastic strap, ask
your TITAN – Adviser for advice.
Check value set on the operator
panel and correct, if required.
Clean gripper plate (6), check
gearing, replace when damage
becomes visible.
Use appropriate plastic strap, ask
your TITAN – Adviser for advice.
Contact TITAN – Service.
57 / 98