Table of Contents
Advertisement
Quick Links
Cronos
Instruction manual
(Rev12 – 05-2018; Firm. vers.4)
WARNING! The user of this instrument must be trained to the use of
power lasers and associated risks. LaserPoint is in no way liable for
any damage resulting from improper, careless or above rated limits
use of this instrument.
LaserPoint srl - Via Burona, 51 - 20090 Vimodrone (Milano) - Italy
Phone +39 02 27 40 02 36 - Telefax +39 02 25 02 91 61
www.laserpoint.eu
1
LaserPoint s.r.l. – Cronos Instruction Manual – All Rights are Reserved
Advertisement
Table of Contents
Related Manuals for LaserPoint Cronos Series
Summary of Contents for LaserPoint Cronos Series
- Page 1 (Rev12 – 05-2018; Firm. vers.4) WARNING! The user of this instrument must be trained to the use of power lasers and associated risks. LaserPoint is in no way liable for any damage resulting from improper, careless or above rated limits use of this instrument.
-
Page 2: Declaration Of Conformity
Section 4.2: Electrostatic discharge. I the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s). Place: Vimodrone - Italia Date: Dr. Luigi Argenti (Technical Director) LaserPoint s.r.l. – Cronos Instruction Manual – All Rights are Reserved... - Page 3 1) In Models LP10 and LP5.0 measured values at wavelengths of CO and YAG are the same, within the specified measurement accuracy. LaserPoint certifies that, at the time of calibration, the above listed instrument meets or exceeds all technical specifications defined at page 8 of this Instruction Manual.
-
Page 4: Operation Section
LED on the right side of the LCS, turns steady green for approximately 5 seconds. At this point, any previously recorded value is zeroed and the instrument is ready to measure. LaserPoint s.r.l. – Cronos Instruction Manual – All Rights are Reserved... -
Page 5: Measurement Cycle
8-Auto Off /Battery Warning As the battery pack is about getting exhausted, a battery symbol pops up on the LCD: it warns you have approx. 10 hours of residual power. LaserPoint s.r.l. – Cronos Instruction Manual – All Rights are Reserved... - Page 6 This is done by limited pushes on the ON/Zero key, until the desired power value is achieved on the display. Reset the switch to its middle position CAL and re-cap. The instrument is ready for new measurements. LaserPoint s.r.l. – Cronos Instruction Manual – All Rights are Reserved...
- Page 7 The symbol apply to all LaserPoint electronic products placed on the European Market after August 13, 2005. LaserPoint will affix the wheeled bin symbol with a bar to appropriate products. The bar indicates that the product was placed on the market after August 13, 2005.
-
Page 8: Technical Specifications
Laser Point. No warranty is given by Laser Point on coatings and battery pack. LaserPoint s.r.l. – Cronos Instruction Manual – All Rights are Reserved...