Stinger Tips; Cleaning Your Stinger - OmniSistem Stinger 1 Series User's Information Manual

STINGER on, no fan, no laser
If still no laser output, call OmniSistem Tech Support @ 253-395-9500 10am-4pm (PST)
Tips: Always use your STINGER in a responsible manner. Here are some tips for
use of the STINGER.
a. The STINGER is for indoor use only.
b. It's best to use a fog machine or a hazer to make the beams more visible.
c. NEVER intentionally direct the beams at anyone's eyes.
d. Beams will be more visible when used in a dark space.
e. Always mount the unit securely.
f. Periodically check the mounting hardware, tighten if necessary.
g. There are no user serviceable parts inside. Do not open unit.
Stinger Cleaning and Care
CAUTION : Applying too much pressure can easily break the special laser mirrors.
If this occurs the unit must be returned for replacement.
Note: If the beam is still fuzzy please contact our service department for a free evaluation
over the phone.
Fan Filter Pack
Your unit has been equipped with a fan filter pack to reduce the amount of fog fluid and airborne
contaminants from entering your projector. We recommend that you clean this filter once every 30 days or
as build up occurs. A blocked filter can impede the unit's performance and cause a failure due to
overheating.
1. Remove the filter
2. Hand Wash the filter material in mild soapy water
3. Rinse with clean water to remove soap
4. Air Dry
5. Replace in filter pack when completely dry.
If your filter is damaged or has worn contact your Stinger Dealer
- Ensure your DMX signal lines are terminated.
- Verify correct power setting, switch "ON"
Cleaning Front Optics
or our service department for a replacement.
© 2009 OmniSistem. All Rights Reserved.
8