General Information - Goodman GPG16 M Series Installation Instructions Manual

HIGH voltaGE!
d
ISconnEct all PoWER bEfoRE
SERvIcInG oR InStallInG tHIS UnIt
M
UltIPlE PoWER SoURcES May bE
. f
PRESEnt aIlURE to do So May caUSE
,
PRoPERty daMaGE PERSonal InjURy oR
.
dEatH
WARNING
.

GENERAL INFORMATION

t
o PREvEnt PRoPERty daMaGE
, ,
oR dEatH dUE to fIRE
, ,
Soot condEnSatIon ElEctRIc SHock oR caRbon
,
MonoxIdE tHIS UnIt MUSt bE PRoPERly InStallEd
, ,
REPaIREd oPERatEd and MaIntaInEd
This unit is approved for outdoor installation ONLY.
Rated performance is achieved after 20 hours of operation.
Rated performance is delivered at the specified airflow.
See product specification sheet for residential packaged
models. Specification sheets can be found at
www.goodmanmfg.com for Goodman brand products.
Within the website, please select the products menu and
then select the submenu for the type of product to be
installed, such as air conditioners or heat pumps, to access
a list of product pages that each contain links to that
model's specification sheet.
To assure that your unit operates safely and efficiently, it
must be installed, operated, and maintained in accordance
with these installation and operating instructions, all local
building codes and ordinances, or in their absence, with
the latest edition of the National Fuel Gas Code NFPA54/
ANSI Z223.1 and National Standard of Canada CAN/CSA
B149 Installation Codes.
EPa R
EGUlatIonS
I : t U
MPoRtant HE nItEd
P a (EPa)
RotEctIon GEncy
REGUlatIonS REGaRdInG tHE IntRodUctIon and
dISPoSal of REfRIGERantS In tHIS UnIt
to folloW tHESE REGUlatIonS May HaRM tHE
EnvIRonMEnt and can lEad to tHE IMPoSItIon of
. b
SUbStantIal fInES EcaUSE REGUlatIonS May vaRy
dUE to PaSSaGE of nEW laWS
tEcHnIcIan PERfoRM any WoRk donE on tHIS UnIt
S
HoUld yoU HavE any qUEStIonS PlEaSE contact tHE
EPa.
local offIcE of tHE
n c
atIonal odES
This product is designed and manufactured to permit
installation in accordance with National Codes. It is the
installer's responsibility to install the product in accordance
with National Codes and/or prevailing local codes and
regulations.
The heating and cooling capacities of the unit should be
greater than or equal to the design heating and cooling
loads of the area to be conditioned. The loads should be
calculated by an approved method or in accordance with
ASHRAE Guide or Manual J - Load Calculations published
by the Air Conditioning Contractors of America.
3
WARNING
,
PERSonal InjURy
, ,
ExPloSIonS SMokE
,
.
S E
tatES nvIRonMEntal
HaS ISSUEd vaRIoUS
. f
aIlURE
,
WE SUGGESt a cERtIfIEd
.