Identification - Grizzly EXTREME Series Owner's Manual

A
I
A. Outfeed Table
B. Fence
C. Cutterhead Guard
D. Fence Controls (refer to Fence Controls on Page 25 for detailed Information)
E. Control Panel (refer to Control Panel on Page 24 for detailed information).
Infeed Table
F.
G. Depth of Cut Scale & Pointer
H. Infeed Table Handwheel & Lock
Outfeed Table Handwheel & Lock
I.
For Your Own Safety Read Instruction Manual Before Operating Jointer
a) Wear eye protection.
b) Always keep cutterhead and drive guards in place and in proper operating condition. If
removed, ALWAYS replace cutterhead guard immediately after rabbeting operations.
c) Never make cuts deeper than
d) Always use hold-down or push blocks when jointing material narrower than 3" or planing
material thinner than 3".
e) Never perform jointing, planing, or rabbeting cuts on pieces shorter than 12" in length.
-4-

Identification

C
B
Figure 1. Model G9860/G9860ZX identification.
⁄ "per pass.
1
8
D
Extreme Series Jointer (Mfd. Since 10/20)
E
F
G
H