Grizzly EXTREME Series Owner's Manual page 45

Models G9953ZX, G9953ZXF
Tools Needed
Machinist's Square ............................................ 1
Bevel Square ..................................................... 1
Open-End Wrench 12mm .................................. 1
Hex Wrench 8mm .............................................. 1
To set 90° fence stop:
DISCONNECT JOINTER FROM POWER!
1.
Loosen fence tilt lock and 90° stop jam nut,
2.
then back off stop bolt (see Figure 67).
90° Stop
Block
Stop Bolt
Jam Nut
Figure 67. Fence 90º stop block components.
Place machinist's square flat on outfeed table
3.
near cutterhead, as shown in Figure 65 on
Page 42, adjust fence to the square, then
tighten fence tilt lock to secure setting.
Tighten stop bolt toward fence assembly until
4.
it becomes snug, then tighten jam nut.
Extreme Series Jointer (Mfd. Since 10/20)
To set 45° fence stop:
Qty
DISCONNECT JOINTER FROM POWER!
1.
Loosen fence tilt lock and 45° stop jam nut,
2.
then back off stop bolt (see Figure 68).
Place bevel square (set at 135°) flat against
3.
outfeed table near cutterhead, as shown in
Figure 66 on Page 42, adjust fence to match
angled face of square, then tighten tilt lock.
Tighten stop bolt toward fence assembly until
4.
it becomes snug, then tighten jam nut.
Tilt Lock
Figure 68. Fence 45º stop block components.
45° Stop
Block
Stop Bolt
Jam Nut
Tilt Lock
-43-