Grizzly EXTREME Series Owner's Manual page 19

NOTICE
Make sure the straps do not touch the con-
trol panel pedestal in the next step. Also,
make sure they stay under the base and do
not slip to the infeed or outfeed tables to
avoid damaging the machine.
Position the lifting straps under the ends of
4.
the cast iron base, as shown in Figure 16,
then secure them to the power lifting equip-
ment.
Figure 16. Lifting straps properly positioned.
Tension the lifting straps with the forklift to
5.
make sure they stay in place, then unbolt the
jointer from the shipping pallet.
With assistance to steady the load, raise the
6.
jointer just enough to clear the shipping pallet
and any floor obstacles, then move it to the
prepared location.
Note: In the next step, use shims between
the base mounting points and the floor to
avoid warping or cracking the cast iron.
As you mount the jointer to the floor, use the
7.
precision level to make sure the table is level
from side-to-side and from front-to-back.
Extreme Series Jointer (Mfd. Since 10/20)
Note: Before the jointer was shipped from the
factory, the infeed table was fully raised and
the stop bolt was threaded up against the bot-
tom of it to safely secure it during transit.
To prevent damaging the table elevation
gearing, you MUST adjust the position of
the infeed stop bolt to the operating position
before attempting to lower the infeed table.
NOTICE
To prevent damage to the table elevation
gearing, NEVER force the table handwheels
if you feel resistance. Check the positions
of the stop bolts or for obstructions.
Loosen the jam nut (see Figure 17) on the
8.
infeed stop bolt, then unthread the stop bolt
until the distance from the top of the bolt and
the bottom of the infeed table is the same as
the maximum depth of cut specified for your
jointer (refer to the Model Specification
Comparison chart for your model on Page 5).
Stop Bolt
Figure 17. Infeed table stop bolt (viewed from
underneath the table).
Jam Nut
-17-