WPC System
USER GUIDE
Rigging WPC with the WPCGRIDi Install Flying Frame
WPC cabinets are normally flown one at a time to form an array in a permanent installation, joining cabinets first at the front
rigging points and then at the rear, selecting each inter-cabinet angle according to your DISPLAY 2.3 project prediction.
An array of up to a maximum of eight WPC cabinets can be flown in this way.
Attach shackles to the front and rear lift points of the Flying Frame. If using only one pickup point attach a shackle to the
pickup hole predicted by the DISPLAY 2.3 project. Offer the Flying Frame up to the first box and attach it to the front rigging
points by inserting a Rigging Pin at each side.
Fig. 36 - attach flying frame
Attach the cabinet drop link to the Flying Frame at the LINK position. Insert a Rigging Pin at the LOCK position on the Flying
Frame.
Fig. 38 - attach flying frame
WPC User Guide v1.0
Fig. 37 - secure flying frame
Fig. 39 - secure flying frame
Page 48