Tripod Mounting; Stacking; Rigging And Suspension - Martin Audio ICT300 User Manual

<
CONTENTS
4.1
The ICT300 incorporates a pole mounting socket to facilitate mounting on
tripod stands. When using stands, the following precautions are advised:
Ensure that the stand will support the weight of the speaker by checking
the stand manufacturers rating.
Make sure that the stand is placed on a level surface and that its legs are
fully extended.
Do not place more than one speaker on each stand.
Run cables so that they do not present a trip hazard which could pull the
speaker over.
When used outdoors in the wind, it may be necessary to add some weight
to the base of the stand.
When using a pole mount with a sub-bass system, observe similar
precautions.
4.2
Ensure that the floor or stage is level and solid.
Do not stack speakers too high outdoors where winds could topple the
stack.
Be aware that speakers producing very high power levels can move or
creep. To avoid this, place friction material between the floor and speaker
and between each speaker.
4.3
WARNING: Suspending the system should only be done by qualified
personnel following safe rigging practices. Secure fixings to the
building structure are vital. Seek help from architects, structural
engineers or other specialists if in any doubt.
>
PRINT

Tripod mounting

Stacking

Rigging and suspension

Martin Audio – M1 and ICT300
4
GUIDES