Teaching FTG Configuration to a TV
This procedure describes how to "Teach" an FTG Configuration file from a USB memory device to a TV.
Ensure you have completed the procedure on the previous page to create the FTG Configuration file
before proceeding with the steps below.
Notes: • If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to
the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described on page 40 or an FMA head end device to reconfigure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU, refer
to Reference section, "Restoring Factory Defaults on the TV(s)," for further information before
proceeding.
1. Turn ON the Target TV, and then plug the USB memory device that
contains the FTG Configuration file into the Target LD660H/LD665H
or LV555H TV USB IN port.
2. Press MENU on the Installer Remote to display the TV setup menus
(TV is in Pass-through Mode) or the Function Menu (TV is already in
FTG Mode).
3. Use the arrow navigation keys to select/highlight either the Option
menu icon from the TV setup menus or the Lock menu icon from the
Function Menu. Then, press the number "7" key a total of seven times
to display the USB Download Menu.
4. Use the Up/Down arrow keys to select Teach To TV (TLX), and then
press ENTER.
5. Use the Up/Down arrow keys to select the FTG Configuration file you
want to install, and then press ENTER.
Teaching status will be shown on a progress bar in a new window.
Do NOT remove the USB device until Teaching is complete. When the
Teaching process is complete, the USB Download menu will reappear
on the screen.
6. When Teaching is done, press RETURN on the Installer Remote to
exit the USB Download Menu, remove the USB memory device from
the Target TV, and turn OFF the TV.
7. After a few seconds, turn ON the TV, and verify that the FTG
Configuration is now resident on the Target TV.
The Target TV CPU is now in FTG Mode (if it was previously in Pass-
through Mode).
Note: When you turn it back ON, the TV will tune according to the Start
Channel setting in the Installer Menu. If a Start Channel is specified, the
TV will tune to that channel; otherwise, the TV will tune to the lowest
logical channel in the FTG Channel Map.
206-4200
FTG Mode via CPU (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Return
Teach To TV (TLX)
xxLD66xH-UA00005.TLX
Return
!
Teach To TV
UPDATING...
Do not unplug!
Enter
Enter
50%
37
Need help?
Do you have a question about the Lodging Guest Interactive Pro: Centric 32LD660H and is the answer not in the manual?